presentation&questions

[faca]

Hi everybody this is my first post.
I notice a big usefull amount of information in this forum, thanks.
#1.I have a cool steel bushman and want to DIY serration spyderco style edge over the back, any advice about to make the best way.
#2.During these Christmas I have received a Christmas gift a Eickhorn PRT II, which is the way to use the break glass pointer?
Some where to check trainning how to use these tool?
#3.Which should be the best location to fix the PRT on my BMW320?
#4.I have a trisharpener from spiderco but I can´t get good edges on my knives which is the correct way to use it?
Thanks in advance.

 

[thombrogan]

I can almost answer the Sharpmaker question. Practice is the largest key, but you may also want to buy a file used for sharpening lawn mower blades to help initially lower the edge before you reprofile down to 30 or 40 degrees. I bought the diamond sleeves, but was told a file will do the same and cost 5 bucks whereas the sleeves cost almost 60.