Pushing 80CrV2 HT a little bit(video)

J W Bensinger

J W Bensinger

Joined
Mar 26, 2009
Messages
2,228
Just trying to push the envelope of differential hardened 80CrV2: 60hrc (ish) edge, flat ground 4" lightweight natchez vs. framing nail.

And just to point out it's not a specially ground nailcutter-it's my EDC. The chip/roll is about .007 deep. The flat grind isn't the most delicate in the world, but I'm still pretty happy with it.
 
Last edited:
If anybody can get the videos to actually appear rather than link pls. Lemme know how to fix it-tried all the options I found.
 
You must log in or register to reply here.
Back
Top