Hi all. I was lucky enough to get a new XM 18 warncliffe this week. I'm new to RHKs and the flipper world too. I noticed while flipping the blade today that I'm squeezing, ever so slightly, on the lock bar. I tried several different hand holds and figured out if I use my wrist I don't need fingers on the lock bar. However, when I just use the flipper I have pressure from my middle and ring finger on the lock bar. Also, I did swap the clip to tip up.
I know the S35VN is @ 61 for hardness. At what point would I be damaging the blade - detent ball interface, or is it a nonissue? I was reading the warantee and service parameters and adjusting detent was specifically listed as a not serviced. I read it to mean if I thought it was too tight or too loose, but it raised the question for me.
I did some searching and did find this specific question answered, so if it has already been discussed please link me to the thread.
Thanks in advance for your help.
Best,
I know the S35VN is @ 61 for hardness. At what point would I be damaging the blade - detent ball interface, or is it a nonissue? I was reading the warantee and service parameters and adjusting detent was specifically listed as a not serviced. I read it to mean if I thought it was too tight or too loose, but it raised the question for me.
I did some searching and did find this specific question answered, so if it has already been discussed please link me to the thread.
Thanks in advance for your help.
Best,