Recommendation? Question on Kershaw Injection knives pivot adjustment

M

maximus83

Joined
Nov 7, 2011
Messages
2,104
Hey can folks who have a Kershaw Injection confirm if you are using a Torx T6 to adjust the pivot?

It looks to me like a Torx T6, which fits in there just fine. But I ripped the soft metal tips off of 2 cheap T6 Torx bits (which definitely says something about the quality of those bits). Wanting to confirm if that's the right bit, or if my eyes are tricking me and I should be using something else. And yes, I ordered some better quality Torx bits, too. :-)
 
Most definitely a T6.
I have completely disassembled mine to clean it, and that's what I used. I just pulled it out of my glove compartment to check (it's my designated car knife) and T6 fits perfectly. It won't take a T7, but if you are extremely careful you might be able to finagle a T5. But I wouldn't recommend it.

BTW I use Wiha precision micro bits. Those I highly recommend!
 
NorthernSouthpaw said:
Most definitely a T6.
I have completely disassembled mine to clean it, and that's what I used. I just pulled it out of my glove compartment to check (it's my designated car knife) and T6 fits perfectly. It won't take a T7, but if you are extremely careful you might be able to finagle a T5. But I wouldn't recommend it.

BTW I use Wiha precision micro bits. Those I highly recommend!
Click to expand...

Ironically, that's what I had just ordered. Decided it was high time to get some quality bits rather than the cheap stuff I had on hand.
 
You must log in or register to reply here.
Back
Top