Random issue with benchmade blades thread.

Status
Not open for further replies.
The subject has been covered numerous times in the past, and with different models. I can't remember if there ever was a definitive answer from BM or not though...
IIRC, the subject first came up when the M4 Mini Grips were released for GP knives.
 
Used to test steel conform. At dedent. End of story that is why it is random, and not on all blades, bm uses a certain item, i pat'ed and mfg until selling system controls to bm. Bm has 100% ownership, sole use and will not, nor will i discuss futher. 2 other units exist outside of bm.
 
The holes found on the blades are used to identify the type of steel before laser marking. Sorry to kill the mystery but we hope that helps :-)
 
Status
Not open for further replies.
Back
Top