The title says it all. Kidding aside 
, here's a few facts.
I recently found an older design of mine that I quite liked but never build. So I worked it over a bit to "modernize" it and went to work.
I build the whole knife (inlc. HT) in one day (with a couple hours break to write applications
). I was finished around 11:30 at night. Then I got it in my head to build a sheath for it as well. That was done around half past one. It was my first sheath in like two years, so I'm pretty pleased how it turned out.
The whole thing is a little gift for somebody who helped me immensely with my Deckel pantograph.
The knife is made from 3 mm 1.2842 (0-2). It's 27 cm long with a 14,5 cm blade. The Pins are stainless and the handle is made from red linen Micarta.
I hope you like it and I'm looking forward to your comments.
Best regards
Marcus
, here's a few facts.I recently found an older design of mine that I quite liked but never build. So I worked it over a bit to "modernize" it and went to work.
I build the whole knife (inlc. HT) in one day (with a couple hours break to write applications
). I was finished around 11:30 at night. Then I got it in my head to build a sheath for it as well. That was done around half past one. It was my first sheath in like two years, so I'm pretty pleased how it turned out. The whole thing is a little gift for somebody who helped me immensely with my Deckel pantograph.
The knife is made from 3 mm 1.2842 (0-2). It's 27 cm long with a 14,5 cm blade. The Pins are stainless and the handle is made from red linen Micarta.
I hope you like it and I'm looking forward to your comments
. Best regards
Marcus
