Redwood Burl and Ladder Pattern

Michael J. Spangler

Michael J. Spangler

Joined
Oct 8, 2003
Messages
2,181
hey guys check it out!

Length: 6 1/2"
Thickness: 1/8"
Blade: Delbert Ealy Ladder Pattern
Handle Material: Stabilized Redwood Burl
Pinstock: 5/32" Stainless Steel
Thumb Checkering
3/16" Lanyard Hole

hope you all like it. its been sitting on my desk for about a week or two. man i need my own computer:grumpy:
 

Attachments

  • reddamascus2.JPG
    reddamascus2.JPG
    32.3 KB · Views: 229
  • redblade2.JPG
    redblade2.JPG
    28.5 KB · Views: 90
  • redhandle2.JPG
    redhandle2.JPG
    38.6 KB · Views: 106
  • redspine2.JPG
    redspine2.JPG
    31.7 KB · Views: 115
Aside from your photos being shite I'd say it looked pretty good! Try using the camera under lights, you dolt! I wanna see the figure in that redwood burl...

Hurry up and go do it again, I'll wait here...
 
Nice mike, but yeah, you need some better ninja camera skills!

Any thoughts of throwing a tung oil finish on it?
 
Good looking little knife. I wonder how the handle feels. Will you be bringing it the HI in May?
 
:DMatt: Bite me

Original: Thanks man

David: actually it's stabilized... just damn fuzzy in pauls crappy photo bix (see how i blame it all one him?) thanks for the compliments man!

Dan: yeah it'll be there unless someone buys it before then. but i have some more on the same idea so you can check em out either way.

take care guys thanks a ton... well except for you matt:D;)
 
You must log in or register to reply here.
Back
Top