Remove Edge Pro Apex Edge?

[Vaporstang]

I have a large Sebenza 21 Insingo that the previous owner sharpened on an Edge Pro Apex. It is very sharp and for all practical purposes I have not used it. I want to sell this in the near future. Since I am sending a couple of other knives in to CRK to have double studs installed, I can send this one along for the ride for a spa treatment and resharpening.

My questions are:
1) Can CRK put back their edge? Will this remove excessive material?
2) Does it really matter from a value point of view if it has been sharpened on an Edge Pro? (Again it is really sharp and looks like it was well done.)

Thanks!

 

[WyattCooper]

CRK will put sharpen it whenever you bring it back to the factory, unless you ask them not to in the form you are required to send. If it is a good edge and the blade has the same profile, the value should not change. And, yes, by sharpening it they will take off a tiny, virtually unnoticeable, amount of metal. Hope this helps!

 

[gull wing]

Why would you want to remove the Edge Pro edge?
Most new knives I get, it's on the Edge Pro to reprofile the edge. Factory edges are usually too steep to slice well.
They cut better with a smaller angle.???????????????

 

[Vaporstang]

Why would you want to remove the Edge Pro edge?
Most new knives I get, it's on the Edge Pro to reprofile the edge. Factory edges are usually too steep to slice well.
They cut better with a smaller angle.???????????????

D'Oh! It was getting late and I wasn't clear in my original post and have edited it. I am fine with the Edge Pro edge for my use. I am asking from a resell value point of view - is it going to affect the value either way? Thanks!