Removing Pinned Handles

[shibdiby]

Hi everyone! I guess I got bit by the Razel bug. I ordered a CRKT Ringed Razel. When I get it, I plan on putting a stonewash finish on it. My only issue, is that I really like the stock handles ( I would make my own Micarta, or cf would also look sharp, but funds are tight:grumpy

So, in short, is there an easy way to remove these handles while keeping them intact to put on after I stone wash?

I'm pretty new here, so take it easy on the newby!

Best Regards,

Dave

 

[peeintheshower]

you would have to drill them out, and then theres no way your going to put them back on.. unless you buy some screws

 

[Rapt_up]

Putting them back is easier than taking them off in my opinion. See how they do it for knifemaking. Corby bolts, screws, flared tubes, pins...

Removal without destruction can be dependent on many variables. Is glue used, and what type? Drilling solid metal pins in a softer material can be a handful