Renegade Tanto WIP

[Rick Haney Design]

Another design I call the Renegade Tanto.This one going to HT.
Hand sculpted Sandvik 19C27 stainless
7.50"OAL
3.25" cutting edge
Ranger green G-10 scales
I'll have finished pics after HT.
Hope you like it.

 

[Lycosa]

Rick---It looks like a little Tuffie. I like it.

 

[Rick Haney Design]

Lycosa,Should cut real well.Feels good in the hand.

 

[Lycosa]

Will you try a FFG on that model?

 

[Rick Haney Design]

Will you try a FFG on that model?

What is FFG?

 

[Lycosa]

A full flat grind. That would add more strength towards the point.

 

[Rick Haney Design]

A full flat grind. That would add more strength towards the point.

I could FFG one.When I carve the next one,I'll leave it thicker at the tip,This cross section should cut like crazy.Really I'm not removing too much more than if you hollow grinded it.Carving allows me to take or leave material where I want.Every knife is new challenge.

 

[Lycosa]

Rick---Tnx!! Keep up the good work. I might snag one of those.

 

[Rick Haney Design]

It's a super penetrator,That what a tanto does best!