replacement washers for cqc7

[solvetek01]

any one know where i can get replacement washers for an emerson cqc7?
The originals look like they are made of teflon or plastic.

 

[Tom Krein]

They are teflon. I would try Emerson Knives....

Tom

 

[STR]

You are up against the odds there. For one Emerson knives use a 1/4" pivot and the washers are thick. I've measured them at .030 and .035 each on some models. On the CQC14 I have here now that I'm converting to a frame lock one washer is .030 and the other .035. Even if you found other washers with the 1/4" hole you'd still be lucky to find any that thick. Most knife suppliers I deal with sell them .020 thick, .015 or .010 so Emerson is your best bet due to the off size of both measurements.

STR

 

[Steve in Minnesota]

You can try your local Fastenal....and the disclaimer....yes I work for them.....and no....I'm not a spammer....just trying to help out.

I don't know what O.D. your washer needs to be but try this:

http://www.fastenal.com/web/products/detail.ex?sku=11103101


Steve

 

[STR]

Those look like they should fit the bill to me Steve.

Good link too.

STR

 

[solvetek01]

Thanks guys