Replacement XM-18 washers

T

Thetimefarm

Basic Member
Joined
Jul 28, 2015
Messages
98
Hey,
I just received a new xm18, one thing I wanted to do was replace the washers with phosphor bronze. I can't find much info on the washer size. I could take down the knife and measure with calipers but if someone knows already that would be much easier. So does anyone know what size washers would fit, plus is there a reliable place to buy them from?
Thanks in advance
 
Well I figured I'd disasseble it at some point so I went ahead and did it. For future refrence the best I can work out is that both washers have a 1/4" inner dia. and a 0.015" thickness, but the outer dia. on the small one (lock side) is 0.43~0.44 inches and the large washer is just 0.5"
 
You must log in or register to reply here.
Back
Top