Screw replacement for ZT 0560?

[daberti]

I just wondered about what measures and threading for ZT 0560, as one of them has just failed and needs replacement.
Sending knife back to USA is out of question, of course.

TIA

 

[whateatsrabbits]

Send CS an email nthey will get some screws out to you asap. How did it Fail?

 

[1SHOT1KILL]

6-32 and 8-32 depending on which screw failed.

 

[Comeuppance]

Just contact Kai and they'll send you new screws for free.

 

[daberti]

@whateatsrabbits
Just done. I guess KAI will take a lot of time, though. I live in Italy.
Just going through my annual manteinance routine I unscrewed the slab. T8 for pivot, T10 for others. They were all way to much overscrewn AND loctited. When the mentioned screw came, its torx "hole" simply went round. Not a great experience at all

@1SHOT1KILL
The bottomest screw on the slabs side.
Then I'd have to check height and diameter unless known by you already.

@Comeuppance
As above

Thanks to you all.

 

[1SHOT1KILL]

8-32 x 3/16 iirc

 

[daberti]

8-32 x 3/16 iirc

Do you mean thread spacing per diameter respectively?
Sorry but I'm a little bit lost with your (imperial) measure references.
I just need diameter/height/thread of course in inches' fractions.

Huge thanks mate

 

[1SHOT1KILL]

Its a number 8 screw 32 threads per inch and the under head length is .187 (3/16" )

 

[daberti]

Its a number 8 screw 32 threads per inch and the under head length is .187 (3/16" )

Got it.
Thanks