Screw Size Spyderco Manix 2 XL

[Black Oak Bladeworks]

Would anyone happen to know the size of the smaller handle screws for the Spyderco manix 2 XL? I lost a screw after cleaning it, and I figured if I am going to replace it I would try and find some slightly longer screws and maybe just put some new scales on the knife as well to make it just a little thicker. The G10 has served me well, but its getting pretty beat up from use. Thanks!

 

[nephron]

If no reponse here, the Customer Service Dept. is great.
Spyderco, Inc
820 Spyderco Way
Golden CO 80403
800-525-7770 (Toll-Free)
303-279-8383 (P)

Business Hours:
Mon-Fri 7:30 am - 4:30 pm (MST)

 

[Black Oak Bladeworks]

I emailed them, but never heard back. I will give calling them a shot next week though. worst case I guess I need a thread gauge. Thanks for the help!

 

[nephron]

I emailed them, but never heard back. I will give calling them a shot next week though. worst case I guess I need a thread gauge. Thanks for the help!

Emails get lost, a phone call will take care of it, the holiday's are problematic too. I usually lay low just before and after holiday's. The experience I have had was quite good. Good Luck,Happy Holiday's.

 

[ferider]

4-40, 1/5 inch long, 100 degree T8 flat-head

Same scale screws as in many other Spydercos, for instance the PM2. 100 degrees is almost impossible to find in generics. Easiest is to buy a couple on ebay.

 

[Black Oak Bladeworks]

4-40, 1/5 inch long, 100 degree T8 flat-head

Same scale screws as in many other Spydercos, for instance the PM2. 100 degrees is almost impossible to find in generics. Easiest is to buy a couple on ebay.

Awesome! Thanks!