Screw Size

[calypso699]

Does anyone know what size the stop pin and stabilizer screws are on my XM-24? Thanks in advance.

 

[CMD2569]

All the information you could possibly need is in this sticky above. Here is the link:


http://www.bladeforums.com/forums/showthread.php/1025624-XM-18-and-XM-24-Knives-Generations-History-and-General-Information

 

[calypso699]

Thanks, there's a lot of good info in there. I did in fact look in there prior to this post but all I found was that the clip screws on older XM's used to be fastened with .05 hex screws. The smallest hex driver I have is 1/16 and that's still too big so I'm assuming the stop pin and stabilizer use .05 but that's just a guess.

 

[RDA]

Does anyone know what size the stop pin and stabilizer screws are on my XM-24? Thanks in advance.

Are you asking about their size or do you want to know what drive they are? If drive, the stop pin screw and the lockbar stabilizer screw are both 0.05" hex drive.

I guess I have something more to add to the FAQ.

 

[calypso699]

Thanks so much RDA. The hex drive info is what I was after. Thanks again and great job on the write up!