screwdriver size for mxggear ZT 0562 hardware?

[sharp_edge]

Does anyone know what size of the slot head driver I should use to install mxggear titanium ZT 0562 hardware? Thanks.

 

[kmboldon]

It's just a slot, can't you just try one or two sizes and see? Is it that you don't have any and need to purchase, or worried about marring the finish?

You could always email mxgear through their contact us link and find out.

 

[sharp_edge]

It's just a slot, can't you just try one or two sizes and see? Is it that you don't have any and need to purchase, or worried about marring the finish?

You could always email mxgear through their contact us link and find out.

The wiha set I have is all torx bits and yes I need to buy one or two quality slot head screwdrivers for this purpose. Titanium screws are softer than steel ones and so I want to use the perfect tool to avoid messing things up. I did email mxggear but thought the good folks here already know the answer.

 

[gunfixrjoe]

Once you get the size, I would recommend good screwdrivers for gunsmithing that are hollow ground. Brownells has good ones. They fit screw slots better to avoid damage.

 

[kmboldon]

The wiha set I have is all torx bits and yes I need to buy one or two quality slot head screwdrivers for this purpose. Titanium screws are softer than steel ones and so I want to use the perfect tool to avoid messing things up. I did email mxggear but thought the good folks here already know the answer.

Got ya. I hope someone comes along with the info. Good luck with the search.