sebbi reassembly story

[mstag]

The other day i took my sebbi apart to clean it. Now ive done this about 5 times in the past and never had a problem. But this time i just could not get it right. first the blade was stiff...then it was not centered, then i couldnt get the handle to sit flush with the blade and bolt up square....so i took a shower and then tried again and it went back together no problem....weird huh...But here is my QUESTION--when reassembeling a sebbi is it possible to do something ,that would make the blade not 100 percent centered. i ask this because when i first got it i could swear it 100 percent centered, now it a little bias away from the lock side. maybe i torqued the bolts down in the wrong sequance. thanks for any help.

 

[ARtsig1]

Take it apart again and check to see if the washers are set right. You probably have one of them off centered and that would cause your problems. There should not be anything but a centered blade on a Sebenza!

 

[TedV]

mstag, did you check the thread at the top of the forum? (or in my sig)

Ted