Sharpening a scrapazachi

[Kayvman]

I'm not sure if this is the right place to post this but I was wondering if the spyderco sharp maker would be able to sharpen the scrapazachi. What do you guys recommend?

 

[darkaether]

it will take forever but it will work. for an edge that long id get it to somebody with a belt sander or paper wheels. SR77 is very easy to reprofile though if you have the patience

 

[drbarnes]

I used my worksharp sharpener with the gaurd taken off to sharpen my waki, and khukris, it works good.

 

[M67]

When I convexed my Rucki, it was actually easy to do with a mouse pas and 400 grit sandpaper to start.

Place the mouse pad on the edge of a table, make sure you have plenty of elbow room, and just sharpen it like you would a normal convex edge. After you get the motion down, it goes quick and you can move up to 600, 800, 1000, etc.

 

[Garth Reckner]

The guys at Scrap Yard will resharpen it for you. You just pay shipping. If you want to do it yourself then I would go with the mouse pad approach.

Garth

 

[Joshua J.]

I agree that the Worksharp would be well suited for tasks like these.

 

[David Brown]

The guys at Scrap Yard will resharpen it for you. You just pay shipping. If you want to do it yourself then I would go with the mouse pad approach.

Garth

This guy has it right

 

[Huntsman Knife Co. LLC.]

Mousepad and sand paper is the way to go if you don't have paper wheels or a belt sander.

Do it yourself and save the money.