Size of torx screws on ZT0300

Bfusmc03117

Bfusmc03117

Joined
Dec 29, 2008
Messages
697
Trying to chnage position of my pocket clip on my ZT300 dont know what size torx head it is out of all the tools i have from working in the car dealerships i dont have tiny torx anyone know what size so i can go out and get it. Thanks
 
I don't own a ZT 0300, but the Kershaw knives I own are T-6 for the scales (and clip), I think.
 
Last edited:
I used to do contract at a diesel engine factory. I'd go to the tool crib and get handfuls of torx wrenches that had little plastic flat heads on them with the size marked. Thos things are great! I keep a T6 and a T8 in my pocket with change everyday for adjusting clips and pivots on my knives.
 
The Kershaw T-Tool comes with T-6 and T-8 bits (and a Phillips). That will cover almost all models. There is one Kershaw knife that uses a T-10, I believe, but I can't remember which one it was. :confused:
 
Some of the late 90s designs use some itty bitty torx heads...the Talon comes to mind.
 
riffraff said:
The Kershaw T-Tool comes with T-6 and T-8 bits (and a Phillips). That will cover almost all models. There is one Kershaw knife that uses a T-10, I believe, but I can't remember which one it was. :confused:
Click to expand...

The Skyline uses the T-10 on the pivot screw.
 
You must log in or register to reply here.
Back
Top