Skeletool edc bit advice

[Furious_Toast]

Hi guys, this is my first post so here goes nothing:
I edc a Leatherman skeletool cx paired with a victorinox swiss champ. I mainly only use the skeletool for the pliers and the blade because I use the Swiss champ for everything else. That being said, I want to replace the bit in the handle with the phillips/screw driver bit from the wave and leave the driver in the handle open. What do you suggest I use in the bit driver that would really come in handy? I'm open to all suggestions and not much is out of my reach in the way of modifications.
Thanks!

 

[Capt. Spaulding]

Welcome to the forum. :thumbup:

Are you saying you wan't to make something to fit in place of the bit in the Skeletool handle?

 

[Furious_Toast]

Thank you!
And yes, either that or something that stays in the driver itself.

 

[Kershaws]

Nothing that your Swiss Champ doesn't have that's for sure

 

[Capt. Spaulding]

Nothing that your Swiss Champ doesn't have that's for sure

That's kind of what I was thinking. I can't think of any small tool that you could make that would not be covered by your Swisschamp.

 

[Macchina]

How about a tiny airspace that may come in handy in many underwater scenarios.

 

[Yalius]

A tightly-folded c-note. You know, for emergencies.

 

[mountainbiker]

What about a torx bit? Or a spudger? A much smaller flat or phillips bit?