Slip Joint - Stockman

S

Shotgunone

Joined
Oct 1, 2000
Messages
244
Three bladed stockman. Antique Jigged bone. 3 5/8 inches closed. ATS 34 blades and springs. Stainless steel bolster and liners. Nickle silver shield.

stockman.jpg


Hope you like it.
 
Very nice knife Tony. I've never been much of a jigged-bone fan but that looks like a real nice specimen. Did you put any filework on this one?
 
Thanks for the comments guys. I'm not sure what the difference is but Remington seems to call there sheeps foot blade a cutoff pen blade on there smaller knives. So I guess you could call that a sheeps foot or cutoff pen blade. I kind of like the sharp turn on the edge though.

Nope Wulf no filework on this one. Since it was my first "sucessful" attempt at making a stockman I concentrated on the mechanics. It is really a pain in the b_tt too get all three blades in there on two back springs and blades passing, folding and not touching. Still have access to nail nicks and all that. The Jigged bone is suppost to be the antique green but it don't have a lot of green to it so I just stopped at antique. This is a finer pick than most jigged bone and I really like it better especially on smaller knives.

Regards
 
You must log in or register to reply here.
Back
Top