Slow speed belt grinder update

[Bri in Chi]

I just installed a 1725 RPM motor in my 1 X 42 Rockwell belt grinder, replacing the 3250 RPM that came with it. What a difference! I sharpened a pair of scisors in a few seconds with a 120 belt. Slow is great!
Here's the deal: http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=92105

 

[Yvsa]

That is greqat Brian. I just have too be careful on my Grizz. If I ever get too where I can stand up and use it for any length of time I may modify it too. They go way too fast as well, but it's good for the buffing side of it.

 

[Bri in Chi]

I like to see the grit grains as they go by

 

[J. MacDonald]

Actually I hear the lower speed is better for buffing as well.

John

 

[clearblue]

thanks for the link --will post results when it arrives and is installed.

I noticed a great price on a 1"X30" belt grinder:

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=2485

 

[Bri in Chi]

Here's my ancient Rockwell 1 X 42 as I have just finished modifying it to run at about 20% of its original speed. The changes include:
H. F. 1725 RPM motor replaced the 3250 RPM stock motor
New power switch located right-front replaced one mounted on motor left-rear
2" motor sheave and 6" drive sheave replaced a 4" and a 3" (as I recall)
urethane link drive belt replaced cloth/rubber V belt
New factory replacement wheels replaced originals that disintegrated

 

[BruiseLeee]

You need to change your sig line now.