Small Sebenza Lanyard Pin Size

M

Marky Mark

Joined
Nov 26, 2011
Messages
59
What is the size of the hole you put the lanyard through on the small sebenza 21 lanyard pin? This may be a question on Jeopardy someday and I want to be ready to answer the question...
 
I got 0.155" on my small.

I measured a couple of lanyard pins and got 0.151"

If anyone is curious the hole in my large is 0.185" +/- 0.002"
and the diameter of a large pin is 0.187" +/- 0.002" by my measurements.
 
Last edited:
I didn't make any measurements of anything but the inside diameter of the hole and the outside diameter of a couple of pins. The pins were not installed in a knife at the time I measured them.
 
How many millimeters will fit into the lanyard pin hole...3mm or 2 mm? I'm. Looking to add a round leather lanyard?
 
0.155" is 3.937mm so 2mm and 3mm should both fit easily.

550 paracord is right at 4mm. Different colors seem to vary a little bit.

I would think that 3mm - 3.5mm would be a good size for a round leather lanyard. 2mm seems a little on the puny side. ;)
 
You must log in or register to reply here.
Back
Top