Smaller pouch for RC-4 sheath add on

R

RangerR47

Joined
Jan 16, 2006
Messages
67
I have seen several post with people showing their add on pouches. Most are about as large or bigger than the sheath itself. What Im looking for is a pouch that is about half the size of the Esee RC5/6 accessory pouch. I want it to hold a Leatherman Juice Xe6 and thats it. Again I have seen the tiny stone pocket and large kit pouch, is there anything in the middle?

Leatherman makes a molle sheath for the large tools that would be about right to attach, but not for the slightly smaller Juice.
 
Thanks, I just found a post where you put a pic of yours with the Max single sheath, that is closer to what I am wanting. I just noticed your a Texan, I was born and raised here in Dallas so good to know fellow Texans hang out in here.

I will have to check those out, would you say that one you showed would be about the size of a Leatherman and not much more? I just dont want it too bulky
 
I would just use a molle pistol mag pouch. It will hold a a Juice with no problems, maybe even a couple other small things if you decided you wanted to add something (firesteel, small knife sharpener). I had my RC-4 rigged with a mag pouch, but took it apart before I took pictures.
 
if you have a decent local army/navy surplus store go there and look for a single magazine pouch for the M9 (Beretta 92).

granted, that will hold a Leatherman Supertool, so it's more than big enough for a Juice. may be too big... but should be reasonably priced.
 
Thanks for the replies, I drive by AFMO.com's storefront everyday so I will have to swing by and check out some pouches in person.
 
It sounds like the small PCC Case from Countycomm.com might work for you.

PCClarge55.jpg

3"L x .7"x .1.8"H
 
You must log in or register to reply here.
Back
Top