Saw a picture that would simplify my explanation so basically I want a simple thin blade to be used like the sayoc RAT.
However I want a different grip for a couple reasons the new stacatto stroup collaboration with the 90 degree hilt is very similar.
So what would I make a 3" with a hard angled tail out of?
Side question is there any metal that would do a good job I could shape entirely with stock removal and have hardened down the road, because if it takes me 8x to get the grip just right paying a knife maker that many times would be expensive.
Or what's the best material for a trainer to figure it out with before getting one made.
However I want a different grip for a couple reasons the new stacatto stroup collaboration with the 90 degree hilt is very similar.
So what would I make a 3" with a hard angled tail out of?
Side question is there any metal that would do a good job I could shape entirely with stock removal and have hardened down the road, because if it takes me 8x to get the grip just right paying a knife maker that many times would be expensive.
Or what's the best material for a trainer to figure it out with before getting one made.
