Something weird happened to my ZT 0700

[BenLong1018]

I took it apart to clean it and when I put it back together the lockbar moved slightly to thr left. This is causing slight up and down blade play which is unacceptable to me. The knife had no up and down play before I took it apart. Could something be a little off causing this? Please let me know if there's anything I can do besides sending it in to the ZT factory.

 

[jstn]

I would take it apart again and thoroughly clean it. Make sure there is no debris anywhere that is causing the lockbar to move. Then reassemble the knife and make sure everything is well tightened.

 

[BenLong1018]

Good idea thanks.

 

[whateatsrabbits]

Also make sure you did not lose the stop pin. You can adjust the lock up by holding the knife a certain way when tightening the bolts.
watch this video, I know its a sebenza but it works on everything,
http://youtu.be/zw3TPYFOp_c

 

[BenLong1018]

Also make sure you did not lose the stop pin. You can adjust the lock up by holding the knife a certain way when tightening the bolts.
watch this video, I know its a sebenza but it works on everything,
http://youtu.be/zw3TPYFOp_c

Thanks I'm gonna try this.

 

[Coolthingy150]

Do you have a video on taking apart the ZT 0700. I can't seem to pull it apart even when I unscrew all the screws. Sorry for the late apply