Speeding up cure time

[mccandmatt]

I'm using JB Weld. I know it isn't west systems. But curious if a little heat is added will it decrease the setup time any, or is it not enough to really matter?

 

[John Katt]

I have read on more then one product that adding heat to speed curing time will yield a weaker bond, unless its below room temperature in your shop

 

[Nathan the Machinist]

Actually, unless they're changed it, real JB Weld (the original formula, not the quick set stuff) is really pretty decent epoxy. I don't use it because it is usually in those little tubes and is pretty expensive per oz and I don't want the grey line it leaves, I don't think there is anything really wrong with it.

Yes, heat will make it set up faster. The effect is significant, just don't over do it.

 

[mccandmatt]

Thanks gents. I just put some bolsters on and want to get the g10 on. But if it weakens the bond I'll leave it