Spokane Washington Makers?

[724wd]

Hello all. I was wondering if there are any Spokane members here, willing to help a budding maker out? I have roughed out my first blade in 5160, but there is so much i don't know! my grinds are a bit sloppy, but there is still meat on the blade...hopefully enough

I am really enjoying monkeying around with this newfound hobby! i have a set of blades i would like to make for hunting, after my skills improve. my next purchase is small trial belt sander. my wife is less enthusiastic about another hobby than i am, so i have to start off small.

Again, any help is greatly appreciated!

Heath

 

[bigbcustom]

If you email me your contact information, I will pass it on to a friend of mine in Genesee Idaho who, though he hasn't been at it for very long, grinds a good blade.