Some questions about the Spydie 204 Tri-Angle Sharpmaker equipped with the optional diamond rods:
-Are the rods good quality, don't they wear too fast?
-Will the rods work superalloy-steels like S90V?
-Are there any special instructions regarding use of the diamond rods?
-What are the rods good for and when should you avoid using them?
-Are they worth the extra cost?
In other words: any experiences, critics, insights, hints regarding these diamond rods is very welcome
-Are the rods good quality, don't they wear too fast?
-Will the rods work superalloy-steels like S90V?
-Are there any special instructions regarding use of the diamond rods?
-What are the rods good for and when should you avoid using them?
-Are they worth the extra cost?
In other words: any experiences, critics, insights, hints regarding these diamond rods is very welcome