Hey everyone, so I've had a G10 dragonfly for nearly 2 months now, and I really like it, the size is perfect for me however I don't like the clip positioning. The wire clip is really great, and whilst I still like the standard full metal clip, the wire clip is more discreet, which is a bonus for me.
However, I think the dragonfly clip should have been positioned where the UKPK clip was, to allow for deeper pocket carry. Its just that when I have it clipped to my pocket, due to its small size, it is very close to the tope of my pocket, and feels a bit unsecure in that it could fall out, and too much is showing at the top I feel.
So I was wondering, if I could get some proper thick metal wire or something like that and make my own clip, basically the same design, yet it goes up higher.
I drew a dodgy pic to help explain
(basically imagine the UKPK clip on the dragonflu, however where it joins to the g10 body and screws down is slightly lower)
stolen from british blades, thanks for the pic David
hopefully this makes sense and you can help me.
However, I think the dragonfly clip should have been positioned where the UKPK clip was, to allow for deeper pocket carry. Its just that when I have it clipped to my pocket, due to its small size, it is very close to the tope of my pocket, and feels a bit unsecure in that it could fall out, and too much is showing at the top I feel.
So I was wondering, if I could get some proper thick metal wire or something like that and make my own clip, basically the same design, yet it goes up higher.
I drew a dodgy pic to help explain

(basically imagine the UKPK clip on the dragonflu, however where it joins to the g10 body and screws down is slightly lower)

stolen from british blades, thanks for the pic David
hopefully this makes sense and you can help me.