Spyderco Paysan Milled Pocket Clips??

JQuirl

JQuirl

Joined
Jan 24, 2016
Messages
248
I feel that I’ve looked every where for a good milled titanium pocket clip for the Paysan with no luck. I am looking for something with a little more bling than just the straight forward deep carry made by Lynch and MXG Gear. Any ideas? Does anyone have a good after market clip for the Nirvana or Paysan?
 
00100lPORTRAIT_00100_BURST20190823145659195_COVER_2_620x.jpg

Perhaps you can use these:
REK Spyderco Clips
It seems its a standard Spyderco pocket that was used on the Paysan... but don't quote me on that. But if it's the case, this one should technically fits.
 
Thank you. I’ve tried this route with Razors Edge, MXG Gear, and Rips Garage Tech. It seems that the hole pattern is the same, but the screws are a much smaller thread pattern on the Paysan. Also the slight contouring on the Paysan throws it out of wack. MXG Gear does sell a deep carry clip with the right screws, but no milled titanium. The only person that makes a milled clip (that I have found) is A. Purvis, but I can’t get him to respond to any emails or messages. I have been trying for three weeks.

I appreciate the quick reply and help.
 
JQuirl said:
Thank you. I’ve tried this route with Razors Edge, MXG Gear, and Rips Garage Tech. It seems that the hole pattern is the same, but the screws are a much smaller thread pattern on the Paysan. Also the slight contouring on the Paysan throws it out of wack. MXG Gear does sell a deep carry clip with the right screws, but no milled titanium. The only person that makes a milled clip (that I have found) is A. Purvis, but I can’t get him to respond to any emails or messages. I have been trying for three weeks.

I appreciate the quick reply and help.
Click to expand...
:p At least i tried! Good luck on your quest!
 
You must log in or register to reply here.
Back
Top