Spydrco Domino bearings problem

T

tomaszlorenc

Joined
Jun 9, 2014
Messages
3
Welcome,
I was forced to disassemble my Domino ( a lot of fine sand inside, no way to clean inside it in simple way ). After cleaning I noticed that the bearings have two different pages, one more flat, the other with a more prominent balls. I dont know witch side adheres to the steel surface which titanium. I know, my error, i don't make a note of it :( Can somebody help me ? I don't want to make a mistake. I found the movie on YT: https://www.youtube.com/watch?v=uUzAtOcdIOg, but my english is very bad, and few understand.

Tomas
 
Last edited:
Hello Barman1,
one side of the bearing has something like a short plastic sleeve around each ball - this side to the blade? I understand? ( sorry ) :(
 
Last edited:
tomaszlorenc said:
Hello Barman1,
one side of the bearing has something like a short plastic sleeve around each ball - this side to the blade? I understand? ( sorry ) :(
Click to expand...

On one side the bearings protrude, "stick out", further. That side contacts the blade and if I remember correctly the "short plastic sleeve" side goes toward the handle. The bearings don't stick out as far on the side with the "sleeves".
I hope that translates well enough for you. :)
 
You must log in or register to reply here.
Back
Top