Straight edge Night Vision!

SkagSig40

SkagSig40

Joined
Feb 1, 2001
Messages
2,671
I just got mine today and it is better than I thought it would be! A very solid knife! I like how wide the blade is for this size knife but I do wish it was a little thicker! I guess I have been using my Tomcat to much!:D Thank you Ron for letting me know you still had a couple for sale! Also thanks Loretta for her help as well!

One question for you. Can I get a wrench to tighten up the screws as they might become loose over time? The screws look like a very small star and i don't know what they are called or what size wrench I would need. The pivit and clip also have a Star shaped screw but a little bigger. Where could find a wrench or could I buy one of each size from SOG? Thanks!!!:)

P.S. Are the liners Stainless Steel or Ti? I didn't see this on the SOG web site. If they are SS are they hardened or left soft?
 
Chris,
The Night Visions take a small Torx driver (T6 and T8?). Try Radio Shack or a number of other places. I got a set in a handle for about 11U$.
I believe the liners are mild stainless, but could be wrong. I filed ridges in the "choil" of my Ti Vision...
 
Sears sells a nice set of "Craftsman" mini-drivers (flat, phillips,torx) for around $20. Since most torx screws are set fairly tight by manufacturers, it's a good deal. Because if you derform one (and you likely will) you can exchange it for a new one under the "Craftsman" warranty. This comes into play when flipping clips for tip up or right/left hand carry, etc.
 
Hi Chris,

Those "star" screws are called Torx head screws. The "little" ones are T-6 and the "bigger" one (the blade pivot) is a T-10.

The liners are stainless steel and are likely hardened, but I don't know for sure.
 
Thank you for the info guys! So far this knife is great! It's lock up is very tight and has no "play" at all in the blade!
 
You must log in or register to reply here.
Back
Top