Strider PT Gen 3 plain ti

[toddbradleefurniture]

I recently purchased a Strider PT Gen 3, plain ti, and love it. I just wish the clip were more flexible.

Has anyone replaced their clip? Does this change anything in regards to the pressure bar? It almost seems the clip is integral to the pressure bar and detent?

Thanks,
todd

 

[shane45-1911]

The clip (assuming it isn't inadvertently bent inwards) should not exert any significant pressure on the lock bar. This applies to any folder, not just Striders.

You can always remove the clip and gently bend it, if you find it is too tight when trying to clip it in your pocket.

 

[toddbradleefurniture]

The clip (assuming it isn't inadvertently bent inwards) should not exert any significant pressure on the lock bar. This applies to any folder, not just Striders.

You can always remove the clip and gently bend it, if you find it is too tight when trying to clip it in your pocket.

This is what I had to do. Bent the clip out so there is a hairline gap. Then I had to take the knife apart to bend the pressure bar in the correct amount. Works like it should now. Thanks.