Stripped Skyline pocket clip screw!

[BenLong1018]

This has never happened to me before and I don't know what to do so some advise would be very much appreciated. Thank you.

 

[OrdnanceBubbaUSMC]

Did you notice the problem while trying to disassemble or reassemble? Also, did you try to switch the screws around?

 

[MadMullet]

Kershaw service is great they will get you fixed up no questions asked send them an Email.

 

[kreole]

Stripped the head or the threads?

 

[BobSig]

I get clockwise and counter confused sometimes too. :grumpy:

Using a hair dryer to heat up the screws/knife before removing the screws will loosen up the locktite. Id start doing that. If you stripped the threads you might be able to add a small amount of copper wire to the hole and get the screws back in with some locktite.

 

[BenLong1018]

Did you notice the problem while trying to disassemble or reassemble? Also, did you try to switch the screws around?

Disassemble.

 

[BenLong1018]

Stripped the head or the threads?

The head.

 

[BenLong1018]

Kershaw service is great they will get you fixed up no questions asked send them an Email.

I agree I have used Kershaw's warranty service before. I'm just really tired of paying to ship my knives out as I've had some bad luck lately.