Swapping handles on Sarsquatch Family

[BlackKnight86]

Hi, guys!

I wanted to swap out the handles on a black/black Sarsquatch and a Competition Grade Sarsquatch. I know there's variation, even between two knives of the same family; but has anyone ever seen enough variation to make this a problem? Ideally, I'd like to do it myself; but if it could turn into a micarta-shaping project, I'll probably send it to the Custom Shop.

Also, I wanted to put the black linen micarta handles on the Comp Sarsquatch with removable rivets...does the Custom Shop offer a removable rivets option?

Thanks!

 

[GregS]

I can almost guarantee you they don't offer removable rivets, if it was removable, it wouldn't be a rivet. As for variation in the handles, the only way to find would be to go ahead and do it, you may got lucky. One can only hope that the handles would be a bit too large, rather than too small, for obvious reasons.

 

[Balislinger]

Heck, just put 'em side by side or trace them to see if they match. It's not that hard to install your own flared tube fasteners