Teeny little damascus knife for a friend

[Danbo]

This knife is so small, I was wondering if my logo would even fit on the knife anywhere.

Damascus mix, unknown, and it didn't really etch with the normal contrast, but it did heat treat nicely and Rockwells at 60 after 3 two hour temper cycles at 400 degrees. Triple normalized and quenched in Brownell's Tough Quench.

I'd call this "just enuff"; it's just big enough, to where a person could actually use it. Just need to put a better edge on it, and get it in the mail soon. In time for Christmas!

 

[Russ Andrews]

Looks like a very handy piece......
Someone will be able to do alot with that..!

 

[canineforge]

Nice, Danbo! I have my Unger sharpened up for opening Christmas presents. :thumbup:

- Joe

 

[John M Cohea]

Your friend should enjoy this one. Nice work.

 

[Doug C]

You're really crankin' 'em out, Danbo.
Nice little one. :thumbup:

Doug

 

[RogerP]

Awwww - it's so cute! Should make for a handy little companion. :thumbup:

Roger

 

[Lycosa]

That's nice!

 

[Keith Montgomery]

Looks like it should do the job. It also looks to be well made.