Tek Lok for ESEE 4

Dragon63005 · Jan 11, 2011

I have a Tek Lok that I bought for my ESEE 3. I received an ESEE 4SOD for Christmas. When I try to use the Tek Lock on it, the holes third down from the top, the screws are too small and go through the holes.

Am I stupid or is there a solution to this?

Thanks in advance.

Lorenzo

obsessis · Jan 11, 2011

Good question.

I got a couple of tek-loks and am going to figure out how to use them with the ESEE-3 and ESEE-4 to use in the horizontal carry across my lower back.

MikePerrin · Jan 11, 2011

run the screws through from the TEK Lock side and put the nuts on the sheath side. The nuts will not go through the holes.

freedoom · Jan 11, 2011

MikePerrin said:
The nuts will not go through the holes.

thats what she said.

MikePerrin · Jan 11, 2011

Well...not these holes anyway.

trailbum · Jan 11, 2011

It will work I had the same setup.

obsessis · Jan 12, 2011

freedoom said:
thats what she said.

always a great one......

Dragon63005 · Jan 13, 2011

MikePerrin said:
Well...not these holes anyway.

Thanks Mike

kfgk14 · Jan 14, 2011

There is a solution.
Doesn't prove or disprove your intelligence

I kid, I kid.
The 4 did have some hardware with it, right? You may be able to play around with some of the included materials and find a good setup. Or find out the thread pitch, and go down to Lowe's/Home Depot.