Tempering a 1060 steel tomahawk

[atpsteve]

I have forged a tomahawk intended for throwing from a block of 1060 steel. After forging and normalizing I heated it to 1500 F. And quenched in parks 50. since it is intended for throwing what temperature would be best to temper it?

Thanks for any help. Also I apologize if this has already been answered elsewhere on the forum

 

[tanglediver]

http://www.uddeholm.com/files/heattreatment-english.pdf
Heat treating steel is more than a casual topic, the rabbit hole runs deep. But don't give up!

 

[Square_peg]

Temper the bit to about 500° F and the eye to 600° or 700° F. Of if you're using colors go for purple on the bit and blue on the eye.