- Joined
- Apr 18, 2007
- Messages
- 327
I've finally brought the Terminus dagger design back- with a few changes!
The blade is hollow ground with a 10" contact wheel on both the top and bottom edges. This makes for an interesting design, and both edges cut very well! The bolsters on this one are slightly dovetailed as well (my first attempt), but it's hard to see in the pics. This is also the first blade to feature my new logo design. At the bottom is a pic of the current Terminus line: dagger, tanto, and drop point (unfinished) shapes.
Specs:
-3.75" blade/ 2.5" top cutting edge, 8 1/4" overall, 1" wide blade
-5/32" thick 154CM stainless steel; Paul Bos heat treat at 58-60 rc
-Mil-spec carbon fiber scales with dovetailed blue G-10 bolsters
Thanks for looking!
The blade is hollow ground with a 10" contact wheel on both the top and bottom edges. This makes for an interesting design, and both edges cut very well! The bolsters on this one are slightly dovetailed as well (my first attempt), but it's hard to see in the pics. This is also the first blade to feature my new logo design. At the bottom is a pic of the current Terminus line: dagger, tanto, and drop point (unfinished) shapes.
Specs:
-3.75" blade/ 2.5" top cutting edge, 8 1/4" overall, 1" wide blade
-5/32" thick 154CM stainless steel; Paul Bos heat treat at 58-60 rc
-Mil-spec carbon fiber scales with dovetailed blue G-10 bolsters
Thanks for looking!
