- Joined
- Oct 19, 2005
- Messages
- 19,746
I actually ordered the little one, and glad I did. Just ordering a knife on Dan's site tought me a considerable amount about knifemaking. Its a K2.5 Karda. A kinda mix between a K2 and a a K3. Dan did it perfectly. THe handle is sandblasted Wenge. Perfect little edc knife. I made the sheath. (pics at bottom)
Next is the Koster Smooth WSK that I recently sold. Tore my heart out to do it, but I needed a KMG. The knife sold in minutes. It was a beauty, in cocobolo. Bottom one!
And finally, I recently handled two of Dan's Ramanon Nessmuks in a passaround. These knives were a pleasure to cut with too. With their wide grind they really did perform as a Nessmuk should.
Check them out in this thread:
http://www.ramanon.com/forum/showthread.php?t=44736
Dan's been a generous teacher and knifemaking rolemodel too. I'm very excited about his forum. And I get to check out his work at Blade again this year too!!!!!
Next is the Koster Smooth WSK that I recently sold. Tore my heart out to do it, but I needed a KMG. The knife sold in minutes. It was a beauty, in cocobolo. Bottom one!
And finally, I recently handled two of Dan's Ramanon Nessmuks in a passaround. These knives were a pleasure to cut with too. With their wide grind they really did perform as a Nessmuk should.
Check them out in this thread:
http://www.ramanon.com/forum/showthread.php?t=44736
Dan's been a generous teacher and knifemaking rolemodel too. I'm very excited about his forum. And I get to check out his work at Blade again this year too!!!!!
