This thing sucks!

[Daniel Fairly Knives]

 

[Daniel Fairly Knives]

I'm stepping it up in every direction! I'm learning how to vacuum form my kydex with molds so sheaths will be even better. Here's my first (semi) successful attempt...

 

[Red Leader]

Daniel, I've been a big fan of your designs for a while now. I've had your 'Clip Point Backpacker' saved as one of my favorite designs for nearly 3 years now, but each time I check your website they are sold out. Any plans to see these come back in? I would love to pick one up as a dedicated neck knife.

Thanks!

 

[Daniel Fairly Knives]

Daniel, I've been a big fan of your designs for a while now. I've had your 'Clip Point Backpacker' saved as one of my favorite designs for nearly 3 years now, but each time I check your website they are sold out. Any plans to see these come back in? I would love to pick one up as a dedicated neck knife.

Thanks!

Hi! Thanks so much, I really appreciate hearing that.

I had to leave in an emergency for TX to go help my bedbound Mom when my Dad passed, after that I got stuck here settling their estate and my CO shop was lost to wind shear. I'm finally getting everything together for a big comeback and have a lot of knives in the works. The clip points are profiled and ready for heat treat, once I get my M4 back from heat treat in a few weeks and sell some knives I will get those out to heat treat and have some ready.

I have put a ton of thought and time into the knives over the last year without any releases, it is going to be good!!!!

 

[Red Leader]

Hi! Thanks so much, I really appreciate hearing that.

I had to leave in an emergency for TX to go help my bedbound Mom when my Dad passed, after that I got stuck here settling their estate and my CO shop was lost to wind shear. I'm finally getting everything together for a big comeback and have a lot of knives in the works. The clip points are profiled and ready for heat treat, once I get my M4 back from heat treat in a few weeks and sell some knives I will get those out to heat treat and have some ready.

I have put a ton of thought and time into the knives over the last year without any releases, it is going to be good!!!!

Daniel,

I'm bummed to hear about all the challenges you've experienced, my condolences sir. Also know that nothing in my message came from a place of frustration, but more as an expression of admiration for your work. Very excited to see you take up bladesmithing again.