Three low riders made to order

[STR]

I knocked a lot out today for you guys.

I usually do these separate for you but due to the fact that these were done without your folders I jumbled them altogether for you.

I've emailed everyone concerned here.

Two Tyrade tip up low riders for two separate customers to drill and tap their own holes. Now what are the chances of that happening at the same time?

And one mini Cyclone tip up low rider.

I have to say I can only hope this Mini Cyclone is folded over in the right spot. Without the knife I can never tell and its a crap shoot.

I'll cross my fingers.

I just have to anodize one of these but I need to look up which one because I forget. I know one of em is a bronze color request. I'll do my best.

STR

 

[STR]

Ok, one is anodized bronze as ordered. That one is the Mini Cylone clip, and I anodized one of the Tyrade low riders blue as requested also.

So at this writing the Mini Cyclone clip is in the mail, and I am still waiting to hear from the two guys wanting the Tyrade clips.

Thanks

STR

 

[ThinkFear]

That Mini-Cyclone clip would be mine. Thanks again STR.

 

[STR]

I guess it fit then?? Show us a pic or three!:thumbup: I wanna see how I did blind.

STR

 

[ThinkFear]

I left my camera at work but, I'll take some pics come Monday.

 

[STR]

Great! So I guess it fit then and you can use it fine? Did it block the lanyard bad because I was hoping it left it open enough to still use it if you wanted?

STR