- Joined
- Oct 13, 1998
- Messages
- 675
I have an Oxo-Acetelene torch that I have been using with a cutting tip. I use a 3-1 O to A pressure ratio. The question is, I just bought a used welding torch, with a flat tip(about 1/2" diam, holes around the edge). What pressure ration should I use?
Aaron
------------------
My sheep has seven gall bladders, that makes me King of the Universe!
aaronm@cs.brandeis.edu
Aaron
------------------
My sheep has seven gall bladders, that makes me King of the Universe!
aaronm@cs.brandeis.edu