Torx Bits for Kershaw Blur

I don't have a blur, but T6, T8, and T10, will cover 99% of knives. I recommend T7 and T9 too if possible, sometimes they're a tighter fit due to different tolerances.
 
drake225 said:
The bits I need to disassemble the Blur are the t6 and t8 right?
Click to expand...

T6 for the handle screws and T8 for the pivot are the right sizes. Make sure to heat up the screws to soften the Blue Loctite. I immerse the knife in boiling water from the microwave for several minutes. Others use soldering irons on individual screws.

BTW: Make sure the blade is in the open position when taking the knife apart.
 
You must log in or register to reply here.
Back
Top