Torx drivers for BM 806

Pete1977 · Feb 10, 2006

Is it possible to find small enough torx drivers to change the clip on an AFCK, or do i need to order the set from BM? I have one config'ed to tip down, and I prefer tip up carry. what is the size of the clip screws, and are sets available at hardware stores etc?

thanx
PEte

Angelus1781 · Feb 10, 2006

If you go to radio shack you should find a small set for computers with small torx drivers. Bought one for 14 bucks and its fit every single knife screw I got.

phatch · Feb 10, 2006

Home Depot has a set too. Cheaper than Radio Shack.

Phil

EpO · Feb 10, 2006

Got a set of bits (no driver) at Harbor Freight for $3.

powells85 · Feb 10, 2006

phatch said:
Home Depot has a set too. Cheaper than Radio Shack.

Phil

Yup, HD has Husky with 4 double ended bits for about $8. Look over in the hand tool section.

mlot51 · Feb 10, 2006

Just for referance- The pivot is a T10 and the rest (including clip) are T6

oldrifleman · Feb 10, 2006

I bought the husky set (4 double ended bits) at Home DEpot for $6. Steven

Pete1977 · Feb 10, 2006

thanks for the info. home depot had a set for 6 bucks.

PEte

bama_lou · Feb 10, 2006

Hello Pete,

If you already own the Home Depot torx driver+ bits, you might notice that the torx driver's shaft was designed to hold the bits minus one. The last one not fitting inside the space was meant to be left stuck on the driver. With a pair of needle nose pliers, you might want to yank out the plastic divider inside the torx driver's hollow shaft. That "mod" will make all the bits fit inside the shaft.

BTW, I learned that here on the forums.

Pete1977 · Feb 10, 2006

Thanks bama lou.

Pete