Transition from two to three rivets?

[Plumberdv]

Could anyone tell me when the 110's went from one rocker pin and two rivets to one rocker pin and three rivets? I've tried reading the timeline sheet, but I've just become confused.

The knife in question is a two dot (.110.) with one rocker pin and three rivets. I'm trying to date it for someone. I know that the two dot was made from 1974 to 1980.

Thanks to any and all.

 

[300Bucks]

Go to the timeline provide at the top of the forum page. 300Bucks

 

[Richard Matheny]

1978 was the year of the change. The change went from two to four to three rivets. The four rivet knives had inlays that were drilled for both two and three rivets to use up the pre-drilled two rivet hole inlay stock in the transition. FYI.

 

[Plumberdv]

Thank you very much. I was having a hard time figuring it out from the timeline.

 

[preacherdc]

I would like to look at the timeline but tell me where it is--I guess I am slow.

 

[Plumberdv]

http://216.26.177.84/forums/showthread.php?t=459010

This should take you to it.

 

[preacherdc]

Thank you Plumberdv for your quick reply, it did get me there.

 

[David Martin]

Plumb, The 2 dot went from 1974-1979. DM

 

[110 Dave]

now on the brass ... when did they go from 4 rivet holes to 3?
i know in 04 there were 4 holes and in 07 there were 3 holes ..
Joe? any one?!