Hi gang,
I can't find a particular thread I was just looking at recently-----apparently I didn't bookmark it either!! :S
In it, someone was describing (with photos) a pretty cool way to hold the blade in the exact same position on the Edge Pro on both sides----it was basically a thin piece of wood/plastic cut out to the blades profile and would 'register' on the blade table. It was thin so you could flip it over and do the other side too.
I can probably figure it out, but if someone has seen this post and can direct me to it, that would be great.
I can't find a particular thread I was just looking at recently-----apparently I didn't bookmark it either!! :S
In it, someone was describing (with photos) a pretty cool way to hold the blade in the exact same position on the Edge Pro on both sides----it was basically a thin piece of wood/plastic cut out to the blades profile and would 'register' on the blade table. It was thin so you could flip it over and do the other side too.
I can probably figure it out, but if someone has seen this post and can direct me to it, that would be great.