deviant11
Knifemaker
- Joined
- Jul 20, 2003
- Messages
- 319
Two more for the Helsinki Knife show.
I can't do hollow grinds on my old grinder and my new machine still doesn't have a motor. So I can only make knives with flat grinds...
Top one is Chad Nichols damascus, black G10 with a beadblast finish.
Bottom one is Alabama damascus, with a carbon fiber handle.
Framelocks off course, with a custom titanium pocket clip and a lanyard hole.
The lanyard hole isn't visible on the front side of the knife.
I tried something new on the backside. I didn't clean up the titanium this time. It's still in it's rough shape. I only anodized it with a propane torch.
I can't do hollow grinds on my old grinder and my new machine still doesn't have a motor. So I can only make knives with flat grinds...
Top one is Chad Nichols damascus, black G10 with a beadblast finish.
Bottom one is Alabama damascus, with a carbon fiber handle.
Framelocks off course, with a custom titanium pocket clip and a lanyard hole.
The lanyard hole isn't visible on the front side of the knife.
I tried something new on the backside. I didn't clean up the titanium this time. It's still in it's rough shape. I only anodized it with a propane torch.
