Updating the knife steel FAQ

[Uncle Bill]

I notice that Joe's excellent knife steel FAQ makes no mention of VG-10 or INFI. Isn't it time for an update?

------------------
Bill

Unfortunate but Increasingly Necessary Disclaimer:

While this post likely contains incorrect information, fuzzy logic, poor grammar and misspelled words, what it does not contain is intentional malevolence toward anyone.

 

[Spark]

Probably. Everytime I get ahold of a more current one, I manage to get embroiled in something that puts the FAQ on the back burner....

Spark

------------------
Kevin Jon Schlossberg
SysOp and Administrator for BladeForums.com

Insert witty quip here

 

[Uncle Bill]

Don't tell my wife about this "embroiled" administrator thing. She might start getting ideas for a new Thanksgiving recipe.

------------------
Bill

Unfortunate but Increasingly Necessary Disclaimer:

While this post likely contains incorrect information, fuzzy logic, poor grammar and misspelled words, what it does not contain is intentional malevolence toward anyone.

 

[Joe Talmadge]

Spark and Bill --

Even in the very latest one, VG-10 is only mentioned in the introduction, it doesn't have its own section. I will try to add that in for this month. I'm not sure I have an accurate picture of INFI's performance, so what I'll probably do is add it into the opening introduction but not give it its own section yet.

For the VG-10 section, I'm going to want to compare it to ATS-34, since that is now the benchmark. My thoughts on VG-10 vs ATS-34: VG-10 is tougher, takes a finer edge, rusts about the same, wear resistance about the same. What do you guys think?

Joe